The factory default IP address for the device is 192.168.1.20 and the subnet mask is 255.255.255.0 (/24) open internet explorer and connect to 192.168.1.20 if you are using one of the latest firmware versions you will be redirected to https and you will see privacy error page You can use this setup to create a link between office buildings up to 50miles (depending on the device) Here. I will be focusing on the selected part of the diagram below for this guide using
Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. This guide can be used on the following Ubiquiti AirMAX devices. This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices.
0 kommentar(er)
